Slipstream Grip (CZ Scorpion Evo 3): Laffs Dynamics
A swept back, rounded butt grip with a ridged texture that wraps around it's front portion. Inner to outer wall thickness is 4mm, with a reinforcing rib down the inside frontal section for increased strength.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 54C
First Layer Print Height: .18mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 4 - 5
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm so it doesn't stick out the side)
1x M4 Hex Nut
File | Extension |
---|---|
Evo Slipstream Grip.zip | zip |
Version: 1.0.0 latest
Slipstream Grip (CZ Scorpion Evo 3): Laffs Dynamics
A swept back, rounded butt grip with a ridged texture that wraps around it's front portion. Inner to outer wall thickness is 4mm, with a reinforcing rib down the inside frontal section for increased strength.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 54C
First Layer Print Height: .18mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 4 - 5
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm so it doesn't stick out the side)
1x M4 Hex Nut
1.6K
Jul 08, 2022
3D Printer
United States
English
QmS2j3s3NGVZia6GQpykzg9pm4SofqXsP4h9q5LEWcgeoY
File | Extension |
---|---|
Evo Slipstream Grip.zip | zip |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.