Target Clip
about
The Target Clip is designed to hold cardboard targets to 0.375” rebar.
Cardboard with a thickness of 0.100” to 0.125” is recommended. The clip is pushed onto the edge of the cardboard, and then snapped onto the rebar stake. Two rebar stakes and several clips on each side of the cardboard may be required. A board with spacing holes drilled in it is recommended to set the spacing of the rebar. This board rests on the ground.
files
| File | Extension |
|---|---|
| README.txt | txt |
| Clip V3.1.STL | STL |
versions
Version: 3.1.0 latest
initial upload
about
The Target Clip is designed to hold cardboard targets to 0.375” rebar.
Cardboard with a thickness of 0.100” to 0.125” is recommended. The clip is pushed onto the edge of the cardboard, and then snapped onto the rebar stake. Two rebar stakes and several clips on each side of the cardboard may be required. A board with spacing holes drilled in it is recommended to set the spacing of the rebar. This board rests on the ground.
creator
Metrics
Views
1.5K
Downloads
122
Project Info
release date
Jun 26, 2023
artifact type
library category
fabrication method
release country
United States
language
English
license
No license
files
| File | Extension |
|---|---|
| README.txt | txt |
| Clip V3.1.STL | STL |
versions
Version: 3.1.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
