Target Point Ruger MKII Grip Panels: FFFTech/FFFTechnology
Grip panel set for Ruger MKII pistols, with concentric split half rings embossed into the panel surface.
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .12mm
Wall Thickness: .40
Wall Perimeters: 4+
Infill: 20%+
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Hardware Needed:
4x Ruger MKII Grip Panel Screws
File | Extension |
---|---|
Target Point MKII Grip Panels.zip | zip |
Version: 1.0.0 latest
Initial release
Target Point Ruger MKII Grip Panels: FFFTech/FFFTechnology
Grip panel set for Ruger MKII pistols, with concentric split half rings embossed into the panel surface.
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .12mm
Wall Thickness: .40
Wall Perimeters: 4+
Infill: 20%+
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Hardware Needed:
4x Ruger MKII Grip Panel Screws
1.5K
120
May 05, 2022
3D Printer
United States
English
QmdR6yNu88V9VwBAD9ZKTuo3ZdrZn9yPayGguMZsieHkDK
File | Extension |
---|---|
Target Point MKII Grip Panels.zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.