Title: The M&P 

Creator: Wunder9

Description: The Smith & Wesson M&P 1.0/2.0 Frame by Wunder 9

Materials Required:

You will need a set of each below for each [x] you make.

- x1 **M&P9 or M&P40 1.0 or 2.0** - Procure a parts kit of your preference.

Instructions:

Suggested print settings:

Material: PLA+ (Recommended)

Layer height: 0.2mm or smaller (Recommended)

Infill: 99-100% (Use best judgement)

Walls: 4-10 (Use best judgement)

Support: Everywhere

Change Log:

BETA v0.03

-Grip extension forward face made flush with rear of magazine well (for smoother magazine insertion)

-First release to include f3d CAD file

BETA v0.02

-Trigger pin hole diameter changed from 0.125 in to 0.15 in (fix trigger pin fit)

-2.0 sear block notch geometry revised (non-mandatory, done to better align hole with locking block protrusion)

-Slight adjustments to rear rail clearances (non-mandatory, adjusted tolarences to better fit 2.0 rear rails)

-Magazine release angle changed from 18 degrees to 23 degrees (shifts magazine 0.04 in upwards to fix 40 cal chambering issues)

-Magazine release moved 0.01 inch upward (done to help move magazine upwards)

-Magazine well moved 0.02 inch rearwards (add clearance for angled mag release, assist in chambering)

-Grip shortened 0.01 inch to account for higher magazine

BETA v0.01

-Initial Release For M&P Beta Testers