Tidal Wave NR M-Lok AFG: Laffs Dynamics
A basic curved angled foregrip with a handstop towards the front. This variant of the original has the ribs removed.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .14mm
Wall Thickness: .40mm
Wall Perimeters: 5+
Infill: 32%
Support Material Percentage: 26%
Print the AFG upside down.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
File | Extension |
---|---|
Tidal Wave NR M-Lok AFG.zip | zip |
Version: 1.0.0 latest
Initial release
Tidal Wave NR M-Lok AFG: Laffs Dynamics
A basic curved angled foregrip with a handstop towards the front. This variant of the original has the ribs removed.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .14mm
Wall Thickness: .40mm
Wall Perimeters: 5+
Infill: 32%
Support Material Percentage: 26%
Print the AFG upside down.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
1.8K
344
Nov 15, 2022
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
Tidal Wave NR M-Lok AFG.zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.