UAMD-1-Srtd: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .12mm
Wall Thickness: .40
Wall Perimeters: 8+
Infill: 50%+
I'm sure someone out there would question adding serrations to an undetectable polymer dagger design.
I'll be blunt, if you don't kill a fucker with an initial stab, perhaps sawing into their flesh will help the process along. It's not about long-lasting durability.
It's about finishing the job.
File | Extension |
---|---|
UAMD-1-Srtd.zip | zip |
Version: 1.0.0 latest
initial upload
UAMD-1-Srtd: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .12mm
Wall Thickness: .40
Wall Perimeters: 8+
Infill: 50%+
I'm sure someone out there would question adding serrations to an undetectable polymer dagger design.
I'll be blunt, if you don't kill a fucker with an initial stab, perhaps sawing into their flesh will help the process along. It's not about long-lasting durability.
It's about finishing the job.
1.5K
240
Feb 06, 2024
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
UAMD-1-Srtd.zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.