It's time I did some shit again, isn't it?
This is a universal Picatinny riser. You can specify how high the second level is above the first, how long the riser is- even the attributes about the picatinny itself, in case it doesn't fit your shit, or you need to change that for your shitty out of clearance printer. Basically this is so universally adjustable that you should never need to buy another riser.
Everything is controlled in the spreadsheet. There's a header line to describe the columns (name, value, notes), the next four lines are about "picatinny definitions", then the height of the top rail over bottom (in this file, it's saved to 20), then there is a clearance percent (how much extra space for the female picatinny model, vs the baseline male), a minimum cross section (by default 4, it's "the thinnest that a piece of plastic should be in the print"), and then the last value in the sheet is the length you want your riser to be- in this file, it's 100.
This Release takes the form of a FreeCAD document. You will need to open it in FreeCAD (which runs on every platform, including Raspberry Pi), select the model, and hit CTRL+E (or File-> Export) to Export it as your desired file type (STL, STEP, etc), and save the exported file.
File | Extension |
---|---|
Universal Riser.FCStd | FCStd |
Version: 1.0.0 latest
initial upload
It's time I did some shit again, isn't it?
This is a universal Picatinny riser. You can specify how high the second level is above the first, how long the riser is- even the attributes about the picatinny itself, in case it doesn't fit your shit, or you need to change that for your shitty out of clearance printer. Basically this is so universally adjustable that you should never need to buy another riser.
Everything is controlled in the spreadsheet. There's a header line to describe the columns (name, value, notes), the next four lines are about "picatinny definitions", then the height of the top rail over bottom (in this file, it's saved to 20), then there is a clearance percent (how much extra space for the female picatinny model, vs the baseline male), a minimum cross section (by default 4, it's "the thinnest that a piece of plastic should be in the print"), and then the last value in the sheet is the length you want your riser to be- in this file, it's 100.
This Release takes the form of a FreeCAD document. You will need to open it in FreeCAD (which runs on every platform, including Raspberry Pi), select the model, and hit CTRL+E (or File-> Export) to Export it as your desired file type (STL, STEP, etc), and save the exported file.
712
180
Jan 11, 2025
United States
English
No license
File | Extension |
---|---|
Universal Riser.FCStd | FCStd |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.