This isn't a full release since documentation is unfinished and assembly is quite similar to v2/

Here's a list of changes:

- Additional spring is now required for the trigger. It can be slightly softer than the spring

  that pushes sliding block/fc slider.

- Mag catch is changed and thus requires different spring (3-4mm ID, <=5mm OD).

- Different magazine. V3 takes extended capacity P17 mags - these are being developed by 

  plcky_shdw, beta channel can be found on Deterrence Dispensed chat. Files for this magazine are not included

  and can only be sourced there.

- Sight slab and adjustable sights are no longer a thing.

- Magnetic delay isn't a thing anymore either.

- No more different frames for different barrels. 16mm OD Shim for 8mm OD liner is included and it can be 

  drilled out to any diameter up to 14mm.

- Experimental suppressor file added. This thing is untested and under any circumstances shouldn't be used

  with smoothbore barrel.

Some general advice:

Supports are still pain in the ass to remove, so your settings should be tuned precisely for easy removal.

I'd recommend to set support overhang angle at 70-75 degrees and use support blockers liberally.

For rifling, ideal tube ID would be 5.45mm. If it's 5.45 or wider, do not bore it any further. It's best to do 

the chambering with 5.7-5.8mm reamer before rifling. Under ideal conditions, chambered bullet should touch or even 

dig in into the grooves.

If it's too hard to push mandrel into the tube, reprint it with negative 0,04-0,06mm horizontal expansion.