The Gen 3 Stock System is a fixed stock intended for use on AR pattern rifles that use a milspec carbine buffer tube.
The goal of the system is to provide an ergonomically correct, light weight stock that is positively retained to the buffer tube and blended smoothly with the lower receiver.
The stock has three choices for butt pads and five different lengths available for full customization. Four different adapters are included to blend with all of the Hoffman Tactical lowers as well as a mil-spec aluminum lower. More options may be available in the future.
The retention device clamps into the bottom of the buffer tube, making for a very strong hold. This allows the rifle to hang from the wall by the stock.
The stock features printed-in-place QD points for attaching sling swivels.
The butt pads may be printed using TPU for maximum comfort and grip.
This is an advanced print. Print pauses, infill modifiers, filament changes, and part scaling will be required to print the stock. Your printer will also need to be properly calibrated to insure a proper fit of the stock over the buffer tube.
File | Extension |
---|---|
Gen 3 Stock System.zip | zip |
Version: 1.0.0 latest
Initial release
The Gen 3 Stock System is a fixed stock intended for use on AR pattern rifles that use a milspec carbine buffer tube.
The goal of the system is to provide an ergonomically correct, light weight stock that is positively retained to the buffer tube and blended smoothly with the lower receiver.
The stock has three choices for butt pads and five different lengths available for full customization. Four different adapters are included to blend with all of the Hoffman Tactical lowers as well as a mil-spec aluminum lower. More options may be available in the future.
The retention device clamps into the bottom of the buffer tube, making for a very strong hold. This allows the rifle to hang from the wall by the stock.
The stock features printed-in-place QD points for attaching sling swivels.
The butt pads may be printed using TPU for maximum comfort and grip.
This is an advanced print. Print pauses, infill modifiers, filament changes, and part scaling will be required to print the stock. Your printer will also need to be properly calibrated to insure a proper fit of the stock over the buffer tube.
2.8K
611
Jul 22, 2022
3D Printer
United States
English
No license
Qmajd9FW7VoCGv76ojGoQr3HXHK7LJYMyWvk81C1STimns
File | Extension |
---|---|
Gen 3 Stock System.zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.